Inspection and maintenance items of the mask production line.

Nov 22, 2020

The production process of the mask production line is more complicated, especially the subsequent disinfection and replacement. The following briefly introduces the inspection and maintenance items of the mask production line.

Inspection and maintenance items of the mask production line:

1. Check and confirm that the ultrasonic system software has not been cleaned, especially the ultrasonic power box, ultrasonic transducer, and ultrasonic mold need to be cleaned, but there is no water, and the connection line is firm. Pay attention to observe whether all ammeters and ammeter needles on the ultrasonic power box are normal.

Mask production line

2. The maintenance requirement of the mask production line is to check whether there is dust on the surface of the motor and other items that endanger the heat dissipation of the heat pipe. Whether the transmission gears, sprockets and chains are oiled, and whether there are accessories. Whether the tightness of the transmission chain is appropriate, whether there is dirt, whether the connecting screw of each casting is loose, etc. The grease of the reducer is generally replaced within 1000 to 1500 hours.

3. Check whether the power circuit connector of the mask production line equipment is loose, whether the main power plug, branch power cord, etc. are damaged, fragile or loose, whether the power box is clean, and whether the exhaust fan is emptied. Matters such as normal work.

4. Check whether the bronchial tube and gas cylinder are leaking, and whether the direction and working condition of the cylinder magnetic induction switch are normal.